Its bootleg and buggy. I am really surprised its being advertised so heavily.
I have used it successfully with elden ring so far.
It crashes the deck forcing auto reboots, launching is a bit of a dice roll on whether you will get a reboot.
I use desktop mode to get it setup (pointing to the tinker launch, and doing the wine3d checkbox)
Like you, nothing is clickable after that in desktop mode. However gaming mode will let you click to login usually. Sometimes it wont and you just have to hard reboot and try again.
Once you can get auto login working and flip wine3d back off, desktop mode still doesnt allow clicking for me, but game mode does usually.
It can take upwards of 20 minutes of rebooting because of unclickable interface, and crash/reboots to get a session going. Another tip is to go slow when launching, and sometimes just wait up to a minute for clicking on aurora to work, and make sure you are closing all the error prompts that pop up as part of the process.
Looking forward to a proper version, but I spend about as much time trying to get it to work as i do playing and i dread trying another game with the current workflow.
If you want a "proper version" then you will have to talk to Valve.
I've noticed a few people having the same problem I've been having, except no one seems to have an answer for it. I've followed all of the steps to a T. Everything loads and logs in fine, but when I open my game, the Aurora is unclickable in game mode, it just starts interacting with the game while Aurora is displayed over everything. Hopefully someone has a workaround for this.
I had the same problem. The solution was to activate developer mode. I didn't have to do anything in the developer mode, just turning it on was enough.
That wasn't in the video or written instructions, so don't feel bad that you missed it.
Someone earlier mentioned disabling Steam overlay too, but I don't recall having to do that.
I've noticed a few people having the same problem I've been having, except no one seems to have an answer for it. I've followed all of the steps to a T. Everything loads and logs in fine, but when I open my game, the Aurora is unclickable in game mode, it just starts interacting with the game while Aurora is displayed over everything. Hopefully someone has a workaround for this.
I had the same problem. The solution was to activate developer mode. I didn't have to do anything in the developer mode, just turning it on was enough.
That wasn't in the video or written instructions, so don't feel bad that you missed it.
Someone earlier mentioned disabling Steam overlay too, but I don't recall having to do that.
I completely forgot to mention that....I did BOTH of those things. Maybe its because Yakuza 0 loads a native controller profile? At this point i'm trying everything lol