Far Cry 6 Message Board  

Has anyone tried manually downloading the trainer into a different place? I have downloaded the trainer from the website and I can successfully activate it on my 1.1.1 UPlay+ version.

Also please open Taskmanager, to go Details tab and verify there is NO Farcry 6 process running before you start the game.

[Edited by 0x90, 10/27/2021 7:04:33 AM]

@0x90
Unfortunately still not running on my end after updating the trainer about 10 minutes ago.

Confirmed no processes of Far Cry were running, even terminated all UCONNECT instances as well. Ran Disk Clean up, manually cleared out windows Temp (just in case). Fresh download and created a new folder on my local C. Double-Checked to confirm no A/V or Malware apps were even running. Still no luck :-(

Same here, I tried what you said and I get the same issue.

And you play the game with UPlay+? Or Epic? Try and see if there is any trainer process activity while it say "Please wait" in taskmanager, like CPU or memory usage goes up/down. I also suggest to just wait a minimum of 10 minutes. Also please tell me if you are running Windows 10 or 11.

I cant currently think of anything that causes this on updated trainer but 1.1.0 was fine for all of you. And for me and Caliber the latest trainer posted here on the website is working fine.

According to the log it attached.

16:44:58 Far Cry 6 1.1.1 (UBISOFTCONNECT/EPIC/UBISOFTPLUS)
16:45:06 Successfully attached to Far Cry 6
16:45:08 Auto Assembler: Symbolhandler is still busy. Waiting for its done...

[Edited by gameswecan, 10/27/2021 7:52:21 AM]

same debug message. symbolhandler is still busy

I'm having the same problem. I have been running win 11 for some time. The only different is windows security is more active. Yesterday was the last time i could play far cry 6 with the trainer. Now it just says: "Please wait..."
I'm running the game from Uplay +.

i´m on Uplay+ but also purchased the game (dont know if that is important) - running win 11, and i have the same issue with the Trainer stucks after pressing F1 with "Please wait....." - i alsdo waited for 20 minutes now and no change.

but maybe this is important -

as i updatet the game - suddenly the game didn´t start anymore (without trainer) and stuck with a black screen in the beginning - so i verified the files via ubi connect - repaired after i´ve been prompted so - then tried to start the game and something started downloading again - and after that the game worked finally.

But the Trainer 1.1.1 stuck on "Please wait...."

But you are right on the Trainer 1.1.0 - it worked fine.

Oh and when i press F1 the CPU raises up to 8 % with the CHTrainer-Task and the memory usage goes up from 112 MB to 116 MB

hope this helps