Cyberpunk 2077 Message Board  

Is it just me or the ghost mode works really bad ?

even if it seems enemies can't find me, but they and cameras, turrets can detect me
so if i need to do something with stealth, it doesn't help

I try to unlock within the Intelligence perk the abilities 'Transmigration' ('Breach Protocol', req. lvl. 16) and/or 'Master RAM Liberator' ('Quickhacking', reg. lvl. 20).
I have the 'Intelligence' on lvl. 20, I set the skill progression on a value that I can reach the amount for level up with the skill progression to either 16 or 20. Works perfectly.
However, the abilities in question are still locked and I am running out of ideas 😔. I have seen that some other member had a very similar question, but no answer. Would appreciate a tip/help. Thanks.

Edit: Somehow managed to get Transmigration - still do not know how.
Edit: Ok, not documented but this is what you do:
(1) You set the perk in question on Level 19 and the related XP to 54999.
(2) You save the game and close the trainer and quit the game.
(3) You start the game, not the trainer, do the relevant activity in order to raise the required perk.
(4) Do some more stuff and eventually you will get it. For some abilities you may need berserk or the right weapon, cyberware.

[Edited by krupps, 2/27/2021 8:56:43 AM]

I am having a problem with this trainer where if I enable unlimited health and stamina, it causes the following issues:

1. For the cyberware perks that give you ram for killing an enemy with a quick hack, it actually causes me to lose that same amount of ram when the enemy dies. For example if I kill 4 enemies with quickhacks instead of getting 4 ram back I lose 4 ram.

2. Sometime my ram just stops regenerating, even though I have several perks and cyberware for it to regenerate x amount per minute or second. Once it happens the only thing I can do is save the game and reload. A reload does always fix this issue.

3. Cyberhacks taking way more ram than what the game says. For example it will say contagion takes 5 ram but when I used it it takes 10 or 11. This makes it impossible for me to use ultimate quick hacks, since they do take 14 and 15 ram, and I have 19. but they are always greyed out, I guess because the calculation is wrong and the game thinks they should take way more than the number that is shown.

If I enable the trainer but never use the unlimited health and stamina option I don't have any issues. If I just don't use the trainer at all I don't have any issues. I installed the cyber engine tweaks and simple menu to get access to the console, then wrote a lua file to give myself 99999 health, and was able to do that and play without it affecting my cyberdeck ram. So this only happens when I very specifically use this trainer and very specifically use the unlimited health and stamina option.

I looked through the last 20 pages or so to see if this is some known issue but didn't see anything. Was wondering if anyone else experienced this and had a work around. If not no big deal since I can just use the combination of cyber engine tweaks and simple menu to get around it.

Hello Team,

I encounter a little problem with the game and the trainer.
When i activate the trainer i lost the control of my two stick of my game pad.
Bet when i press and maintain RB button i can use the two stick, when i release RB again i lost the control.

I select none on control trigger option with same result

18:10:45: Controller detected
18:10:46: Cyberpunk 2077, 1.12 (STEAM/GOG/EPIC)
18:12:44: Successfully attached to Cyberpunk2077
18:12:46: Seed = 379805093

Someone encounter the same thing?

Thank you for your help

Because you have to press F1 again to re-enable the controller, just like it was written in about every other forum post about this game.

Thank you for your help

So I have tried both the 1.11 and 1.12 version of the trainer and they act the same way. I press F1 to enable, then press it again to enable the controller support but then I just float. It is kind of like no clipping is enabled.

Also if I use the infinite health option I can not hack anything as I have no RAM. I suspect it isnt the trainer as much as the game itself.

Delete trainer and all files in

C:\Users\USERNAMEHERE\AppData\Local\Temp
C:\Users\USERNAMEHERE\Cheathappens\Work
C:\Users\USERNAMEHERE\AppData\Roaming\Cheat Happens\0x90
C:\ProgramData\CheatHappens

Learn how to make your own Trainer Cleaner for the above paths Here. Link

Reboot PC to clear excess memory, get a fresh copy of latest trainer and extract it. Run trainer as admin, read the instructions and try again. At times, a new game may be needed to resolve failed options if the data in your save file was altered. Use on a new game and test the option. If it now works, quit to main menu and load your save and try it again. May also need to run the game without the trainer first and play a bit so the save file gets updated to use possible new values.

[Edited by CyPHeR369, 3/9/2021 2:47:57 PM]