Ghost Recon: Breakpoint Message Board  

trainer fails to launch. followed all instructions when i press F1 it says "failed"

log:
16:17:11: Failed attaching to process (ERROR_ACCESS_DENIED) which means the game is very likely protected by anticheat software. Please check out the trainer notes to see if there are any special instructions.

epic games version of game. v.6746190 04-17-2023

did you follow the instructions?

Hi, am getting the same error message as the original poster.

Followed all the steps,
including uninstalling BE and changing the .ini file.

I am running from Ubisoft Connect.

Thanks.

did you follow the steps in the readme?

[Edited by moderator Nook, 5/16/2023 11:46:50 PM]

Howdy folks, I did pop in an update request but just checking.

The trainer comes up with failed when attempting to use the trainer, followed the trainer instructions. Im not sure if theres a difference between a purchased copy of the game or the uplay+ version.

Hi Timothy3636.

If you followed all the instructions as per readme and in the video posted on the previous page and it still doesn't work, then an update request is correct.
There is often a difference between those, as for our trainer and readme I can't see any difference. You would have to still do the same parameters and the battleeye.
Once it has enough reports our trainer monkeys and/or trainer maker will have a look.

[Edited by moderator SmileyJ, 5/21/2023 3:24:41 AM]

Trainer is working as intended and up to date. This is my only suggestions..

NEW! NO NEED FOR LAUNCHER!

MAKE SURE YOU RUN THE GAME ONCE WITHOUT THE TRAINER TO MAKE SURE IT IS RUNNING NORMALLY. USE VERIFY FILES IN UPLAY TO FIX THE GAME IF IT WONT RUN. ONCE THE GAME HAS RUN ONCE, THEN YOU CAN DO THE FOLLOWING!

For UBISOFT CONNECT, select the game, select PROPERTIES, then in GAME LAUNCH ARGUMENTS type:

/belaunch -be

Then launch the game and the trainer will be able to connect to the game.

For STEAM, select the game by RIGHT CLICK, then select PROPERTIES, then GENERAL, then in LAUNCH OPTIONS type:

/belaunch -be

Then launch the game and the trainer will be able to connect to the game.

For EPIC, click your USERNAME ICON at top right, click SETTINGS, then scroll down to your game, Click the game to expand the options, select ADDITIONAL COMMAND LINE ARGUMENTS, then type:

/belaunch -be

Then launch the game and the trainer will be able to connect to the game.

If the game still has issues with trainer connecting, try this parameter instead of the other one.

/be_launch_1VSM0

And then see if the trainer will work then.

If you still have issues after that try:

Navigate to < path-to-game >\BattlEye
folder in the game folder.
Run Uninstall_BattlEye.bat.
Open BELauncher.ini.
Set SilentInstall to 0.
Run the game and turn down any prompt to install BattleEye again, usually CANCEL.