Ghost Recon: Breakpoint Message Board  

trainer's not working anymore, at least for me, i've tried to launch game via trainer but uplay opens the main interface, not starts the game.

Ok what am i doing wrong here.
Have been using trainers for this game since the first version and have had no problems.
But cant seem to get latest one to work
Install trainer into game folder
unzip launcher into game folder
Start trainer
Use CH Launcher to start game
Press F1 when i get to the screen where i choose my character
Get FAILED from trainer ?????

Check to make sure the trainer version matches the game version and makesure any Anti virus is ignoreing the trainer and run the game and the trainer in admin mode. Also if you are able please post the debug information here to.

korbagor posted on Feb 08, 2020 4:06:08 PM

trainer's not working anymore, at least for me, i've tried to launch game via trainer
but uplay opens the main interface, not starts the game.





Just a tip, I have also noticed that the trainer does not activate immediately, I clear the fault from the trainer and wait for 10-30 seconds and click to go back to the trainer and hit F1 again to activate it. Sometimes it takes a few tries to get the trainer to recognize that BattleEye has truly been disabled and then it will activate.
Warning DO NOT close the trainer or otherwise you will have to start from the beginning again with launching the game. Like I said it takes me few tries to get the trainer activated.
Hope this helped out.

[Edited by bopet, 2/9/2020 10:43:48 AM]

Game crashes everytime I press OK at Main menu. Ran as admin and followed all steps. This didn't happen before.

I have always FAILED for me. A problem with battleEye. In trainer I have message with failed problem with anticheat. But I installed Launcher in game path. Its not my first trainer for this game. I don't know where is problem 😭

Verify your files via Uplay game properties, run the game once with no trainer and shut it down. Then use the launcher and follow all prompts to the letter.

I verified files and had error with files. I repaired files. I deleted my launcher in game path. So I run game in normal mod (without trainer and launcher). All work.... normal.
So I copy launcher from trainer in game path, I run it then trainer.
And....... always failed.
Exactly I have that :
20:34:16: Ghost Recon Breakpoint, V.4805542 (UPLAY)
20:34:21: Failed attaching to process. Very likely the game is protected by anticheat software. Please check out the trainer notes to see if there are any special instructions.