Hello,
This trainer is working perfectly exactly the location in Editor.
When I try and do what it says, run escape cpy location settings go back in game. It just runs on the same spot like it's walled in.
I don't follow you??? Can you re-phrase that a bit better, I don't understand what you mean.
So basicly,
When I go into the "Editor" tab, I already have a waypoint selected ingame.
I copy over from waypoint to player in CH, after that I go back into the game (have to alt tab). Whenever I do this it just runs on the exact same square like it's boxed in.
It doesn't actually physicly transfer it.
All values edited? X Y and Z? None of them have a ?? displayed do they? You may be trying to go too far, try to keep it within about 4 blocks or the game may not sync with your character.
If you are going to try to teleport, make sure your character is in the act of movement, such as running, then press ESC to open the MAP, then click somewhere to set up a waypoint, then use that data to try and change your position. For Z, maybe add a slight amount to account for differences in map height.
Probably best not to go further than 4 blocks. You can also use this to get to heights or inside or to things you weren't able to do otherwise.
• Waypoint Location' Location X:
You can try to use these numbers to move your character to a location using the Player Location editor. Moving to some areas, areas not found, or too far can result in the game doing an unsync. So use with caution. You can always RELOAD LAST CHECKPOINT if it gets stuck.
[Edited by CyPHeR369, 10/25/2020 3:11:53 PM]
I have tried doing this even 2 blocks is giving me the same issue.
Don't have a copy of the game to test, check the CH discord. One of the testers can assist better perhaps.
If someone has this game on EPIC, can they test and report back if the trainer we have here already works for it?
best,
Cal
it does not work for epic, when trying to load the trainer it says cannot find game.
Important Board Topics
Trending Topics