Civilization 6 Message Board  

Hi guys, getting this message:

16:35:18: Trainer is up to date.
16:41:00: Successfully attached to CivilizationVI_DX12
16:41:00: Symbolhandler: Enumerating symbols...
16:41:01: Symbolhandler: Finished! Time enumerating symbols: 389ms
16:41:01: Capture Unit Base Address, Script error in line 6: The module name 'GameCore_XP2_FinalRelease.dll' does not exist!

Make sure you have the gathering storm DLC enabled, and activate the trainer in-game where u can can move units around.

sigh..

Trainer for 1.0.0.341 443561

is here:

1. Civilization 6 Trainer 1.0.0.341 443561 (DX11+12) GATHERING STORM

www.cheathappens.com/22063-PC-Civilization-6-trainer

and tested working as intended and as instructions say.

We even put a sticky here:

www.cheathappens.com/show_board2.asp?headID=141926&titleID=22063

as well as instructions IN the trainer:

NOTE
=====

This trainer is for Civilization VI with the Gathering Storm Expansion ONLY! It will not work unless you own the Civilization VI Gathering Storm expansion and have it ENABLED in the "Additional Content" menu at the main menu. We NO LONGER support any other versions or expansions of the game, ONLY Civilization VI Gathering Storm will be supported from now on. This also means that if you only own vanilla Civilization VI with no expansions or only own the Rise and Fall expansion, this trainer will not work for you! You MUST own the Civilization VI Gathering Storm expansion and have it enabled!

This game dynamically loads and unloads and reloads the game .dll while you play, especially if you restart, or are loading or starting a new game. Please note that this means many options will no longer work and will need to be turned off and then turned back on, since the game is reloading the addresses in a new .dll. The best way to use this trainer is to wait until you start your game and are able to move units and click on cities BEFORE you activate the trainer. It's also best to close the trainer and restart the trainer if you restart the game, load a save, or do anything to start a new game or load a new game.




best,
Cal

I have to ask this, why are there not DX12 trainers? I do have a LITTLE programming training, so go easy on me, OK?

Dark

huh?

1. Civilization 6 Trainer 1.0.0.341 443561 (DX11+12) GATHERING STORM

I have an issue when using the trainer where my entire HUD disappears and i cannot do anything. So far only occurs when using unlimited movement. has happened it two separate instances, one where i was moving a unit during my turn. i am able to save and reload and it fixes that, but once i end my turn the second instance occurs where the hud goes blank and i can no longer save or load the game.

Hey, I understand that the trainer only works at gathering storm dlc and you have to activate once you loaded in game, it works for sometime and then my game crashes. Anyone got a fix for that?

no because this doesn't occur here.

further

"game crashes after some time"

is completely useless information.

We need a savegame that crashes repeatedly at the same place or same instance or same action.

best,
Cal