Dragon Ball Xenoverse 2 Message Board  

The trainer tries to get the installation directory of the game via registry:

SOFTWARE\Wow6432Node\Valve\Steam\InstallPath + \steamapps\common\DB Xenoverse 2\Start.exe

If this file does not exist, it tells you to select the start.exe manually which opens a file dialog in where you have to select the start.exe inside the game directory and press the 'OK' button. Then it checks if the file you selected exists, if not it says "Start.exe was not found".

There are couple of ways to fix this. Install game in default steamapps directory or, select the start.exe INSIDE THE GAME DIRECTORY via the openfiledialog of the trainer when it tells you to do it.

I get this error for some reason.

anyone know why?

When you attach a file to the site only staff/support can see it.

Yes, because EAC is still enabled.

Please read the instructions regarding how to use our trainer and what to do.

I followed the instructions. Its odd because It was around a week ago. I haven't changed anything. I'll try again with a few more variations and see if it works.

UPDATE: Still isn't working at all. Same error.

[Edited by Mastersuleman, 2/21/2018 9:32:09 AM]

Access denied, unless the trainer got blocked by anything else (unlikely but not impossible) highly indiciates that EAC is still running.

Please make sure you followed the instructions correctly:
Link

Please note that on a game update and/or start, it can happen that the game/steam reinstalls EAC. You can verify it if there is an EasyAntiCheat process running while the game is opened or if you launch the EAC installer again, the "uninstall" button is not greyed out.

Hi there folks! I have followed all instructions on how to run the game properly, but keep receiving an error message which follows:

System.ComponentModel.Win32Exception (0x80004005): Access is denied
at System.Diagnostics.NtProcessManager.GetModuleInfos(Int32 processId, Boolean firstModuleOnly)
at System.Diagnostics.ProcessManager.GetModuleInfos(Int32 processId)
at System.Diagnostics.Process.get_Modules()
at ‮‪‍‮‬‭‫‮‭‬‌‪‮‏‍‍​​‪‮‎‍‎‮‌‬‮‮.GetModuleBaseAdress(String )
at ‮‪‍‮‬‭‫‮‭‬‌‪‮‏‍‍​​‪‮‎‍‎‮‌‬‮‮.AttachToProcessByName(String , Boolean , Int32 , ‮‎‬‭‮‌‍‫‪‫‏‍‌‬‪‭‍​​‭‮‏‏‮‏‭‌‮ )
at o-Qa0#oQ at o-Qa0#oQ at System.Windows.Forms.Timer.OnTick(EventArgs e)
at System.Windows.Forms.Timer.TimerNativeWindow.WndProc(Message& m)
at System.Windows.Forms.NativeWindow.Callback(IntPtr hWnd, Int32 msg, IntPtr wparam, IntPtr lparam)

Any assistance would be greatly appreciated! Thank you!

Should I just ask you to read the posts above yours or do I need to tell you that EAC is still enabled and installed?