Command & Conquer 3: Kane´s Wrath Message Board  

I've got an issue regarding the C&C3 KW Mega Trainer. I've got the STEAM version of Kane's Wrath installed, but the problem isn't the fact that the trainer isn't working, far from it. It's the game itself when I activate my trainer. Every time the game goes into a loading phase to go into game play after I active the trainer, the game crashes. I've looked at the Troubleshooting guide, but that for if the TRAINER fails. This is the game failing, not the trainer. Oddly enough, I can run the trainer, and the game will run if trainer stays inactive. Can anyone direct me to a fix for this problem?

[Edited by NFSRacer, 12/30/2010 5:04:10 PM]

Well..

The game got updated to 1.03, the trainer is for 1.02

Thats the reason..

[Edited by Wolf-dk1984, 1/1/2011 4:19:51 PM]

Odd. The version I'm running for the game is 1.02, but the trainer, I believe is also 1.02. I'd have to look again, but I swear that's what I'm running, because not even the normal trainers will work, let alone the mega trainer.

Well..

Yep, my version is now 1.02

Apparently the update got BackRolled, for reasons unknown..

Maby it was the AntiCheat system that got updated all along, bacause i couldent join any multiplayer games, i can now..

Well, is there any way to fix this problem? I'm running a STEAM version of KW, so I'm not sure I have the same freedom that you might have, if you have the hard copy.

Just use crack, it will fix the problem.

I am using the crack, but the thing is, it's still not making any difference. All it did was make it so I can run the game outside the STEAM interface, but I still can't use the trainer.

I'm using the steam version 1.2
However when I load my campaign and hit play I get a error and the game crashes.

[Edited by Zugustaz, 1/4/2011 5:00:21 AM]